Setting For The Lan To Connect The Multiple Units; Selecting The Monitor (Designation Of The Monitor Or Group Id Number) - Sony Trimaster PVM-L3200 Operation Manual

After saving and reflecting the setting, you can change the
setting with the menu.
• Color Temp (color temperature) (page 52)
• Setup Level (NTSC Setup Level: page 54, Betacam
Setup Level: page 54)
• Component Level (page 54)
• Color Gamut Emulation (page 54)
Setting for the LAN to Connect the
Multiple Units
You can control the multiple monitors using the controller
connected via each LAN (10/100) connector. You can also
control a specific monitor or monitor group.
Set an IP address to the monitors and the controller and a
monitor ID number and group ID number to each monitor.
1
Set the NETWORK switches of each monitor and the
controller to PEER TO PEER.
PEER TO
PEER
NETWORK
LAN
NETWORK
LAN
2
Set the different IP address to each monitor and the
controller.
Monitor: Set the IP address in the Network Setting
menu (page 66) of the System Configuration menu.
PEER TO PEER
Controller: Set the IP address in the Network Setting
menu (page 77) of the Controller menu.
3
Set Monitor ID and Group ID in the Network menu
(page 66) of the System Configuration menu.
Set the different monitor ID number to each monitor
and if necessary, group ID number.
You can use the numbers 1 to 99 as a monitor ID
number or group ID number.
4
Set the NETWORK switches of the monitor and the
controller to LAN.
PEER TO
PEER
NETWORK
LAN
NETWORK
LAN
Selecting the Monitor (Designation
of the Monitor or Group ID Number)
When the multiple monitors are connected by the network
connections, you can remotely connect the monitors from
the controller by designating the set monitor ID number or
group ID number.
PEER TO PEER
Settings
29