Setting For The Lan To Connect The Multiple Units; Selecting The Monitor (Designation Of The Monitor Or Group Id Number) - Sony BVM-F170 Operation Manual

After saving and reflecting the setting, you can change the
setting with the menu.
• Color Temp (color temperature) (page 47)
• Setup Level (NTSC Setup Level: page 49, Betacam
Setup Level: page 49)
• Component Level (page 49)
• Color Profile (page 48)
Setting for the LAN to Connect the
Multiple Units
You can control the multiple monitors using the controller
connected via each LAN (10/100) connector. You can also
control a specific monitor or monitor group.
Set an IP address to the monitors and the controller and a
monitor ID number and group ID number to each monitor.
1
Set the NETWORK switches of each monitor and the
controller to PEER TO PEER.
NETWORK switch
tSet to PEER TO PEER.
2
Set the different IP address to each monitor and the
controller.
Monitor: Set the IP address in the Network Setting
menu (page 61) of the System Configuration menu.
Controller: Set the IP address in the Network Setting
menu (page 71) of the Controller menu.
3
Set Monitor ID and Group ID in the Network menu
(page 61) of the System Configuration menu.
Set the different monitor ID number to each monitor
and if necessary, group ID number.
You can use the numbers 1 to 99 as a monitor ID
number or group ID number.
NETWORK switch
t Set to PEER TO PEER.
4
Set the NETWORK switches of the monitor and the
controller to LAN.
Selecting the Monitor (Designation
of the Monitor or Group ID Number)
When the multiple monitors are connected by the network
connections, you can remotely connect the monitors from
the controller by designating the set monitor ID number or
group ID number.
Display window
Lamp
3
2
1
Press the corresponding button to select the connection
mode.
SINGLE button: Selects single connection mode.
The designated monitor is connected remotely.
The monitor ID number is displayed on all connected
monitors when the button is held pressed.
NETWORK switch
tSet to LAN.
NETWORK switch
tSet to LAN.
1
2
3
Settings
25