Connecting The Power Cord; To Connect The Ac Power Cord; Turning On The Monitor - Sony BVM-E251 Operating Instructions Manual

Connecting the Power
Cord
You can operate the monitor with AC or DC power
supply.

To connect the AC power cord

1
Plug the AC power cord into the AC IN connector
on the rear panel then attach the AC plug holder
(supplied) to the AC power cord.
AC power cord (supplied)
2
Slide the AC plug holder over the cord until it locks.
To remove the AC power cord
Pull out the AC plug holder while pressing the lock
levers.
To connect the DC power supply
Connect the DC power supply to the DC IN 24V - 28V
connector.
When the AC power cord and DC power supply are
connected, the AC power supply is given preference over
the DC power supply. To use the DC power supply,
disconnect the AC power cord.
AC IN connector
AC plug holder
(supplied)

Turning on the Monitor

Press the power switch on the rear panel to turn on the
power.
When you turn on the monitor for the first time after
purchasing it, the [Select Area] screen is displayed. Select
the area where you intend to use this monitor.
For selecting the area, see page 20.
The warm-up time is more than 30 minutes,
approximately.
When the monitor is in sleep mode
As the OPERATE indicator lights in red in sleep mode,
press the MONITOR switch of the controller.
The OPERATE indicator lights in green and the monitor
enters operation mode.
19

Connecting the Power Cord