Turning On The Monitor; Settings; Selecting The Area - Sony BVM-F170 Operation Manual

Turning on the Monitor

Press the MAIN POWER switch on the rear panel to turn
on the power.
When you turn on the monitor for the first time after
purchasing it, the Select Area screen is displayed. Select
the area where you intend to use this monitor.
For selecting the area, see page 23.
The warm-up time is more than 30 minutes, approximately.
When the monitor is in standby mode
As the OPERATE lamp lights in red in standby mode,
press the MONITOR I/1 switch of the controller.
The OPERATE lamp lights in green and the monitor enters
operation mode.

Settings

Selecting the Area

When you turn on the monitor for the first time after
purchasing it, select the area where you intend to use this
monitor from among the options.
When the area is selected, the menu item settings suitable
for the selected area are applied.
Default value for each area
5
4
3
3
Color
Temp
1North America D65
2Latin America
Argentina D65
PAL&PAL-N
Paraguay D65
Area
Uruguay D65
NTSC&PAL-
Other Area D65
M Area
3Africa
Australasia
D65
Europe
Middle-East
NTSC Area D65
4Asia Except
Japan
PAL Area D65
D93
5Japan
3
1
2
Setup Component Color
Level Level Profile
ITU-R
7.5% Betacam
BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
ITU-R
7.5% Betacam
BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
ITU-R
7.5% Betacam
BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
23
Settings