Table of Contents
Advertisement
6
Attach the cable cover (L).
Slide the cable cover (L), while sliding the
slide locks (2 pcs), which are located at the
bottom of the monitor, in the reverse
direction of step2.
Notes
After attaching the cable cover (L), check
that the slide locks (2 pcs) return to the
original position. The cable cover (L) may
fall off if it is improperly locked.
If you use a connection cable that is bigger
than the cable holder or cable cover and it
cannot be fit in, do not secure it in the
cable holder and use the cable with the
cable cover removed.
Caution
This unit with the cable covers attached
conforms to the waterproofed standard. (See
page 35)
Be sure not to use the unit with the cable covers
removed since waterproofed performance is not
guaranteed.
To unplug the AC power cord
Press the (On)/
(Standby) switch to the
(Standby) side to set the unit to the standby
state, then unplug the AC power cord from the
AC power plug holder by holding both sides of
the fixing levers of the holder to release the lock.
Turning on the Monitor/Switching Input
Settings
1
Connect the plug of the AC power cord to an
AC outlet.
2
Press the (On)/
(On) side to turn on the monitor.
The power indicator on the front panel lights
in green.
3
Switch the input settings.
If the desired image is not displayed, press
the CONTROL button to show the operation
buttons on the front panel, then press
PORT A or
For details on switching the input settings, refer
to "Location and Function of Parts and Controls"
on page 17 or "Input/Output Configuration
menu" on page 30.
24
(Standby) switch to the
PORT B.
Advertisement
Table of Contents
