Removing The Printer Unit Chassis - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

14. Disconnect the harness from the registration motor.
15.
Disconnect the main cooling fan wiring harness from the low voltage
power supply. Disconnect and remove the chassis cooling fan, it is held
in place by two screws.
16. Remove the two screws securing the AC inlet. Remove the screw
securing the ground wire near the power switch.
17. Disconnect connectors SHUTTER, PARTTEMP, DCL, FSENS and
SHUTTER1 from the print engine controller board.
18. Remove the ten screws securing the printer unit chassis to the frame.
19.
Lift the chassis about 7.5 cm (3 in.) while guiding the AC receptacle
wiring through the rear chassis frame. Also guide the printer unit
chassis past the wiring at the front of the electrical chassis.
20. Lift the printer unit chassis from the main chassis Rest the chassis
upside-down on a table.
Note
The low-voltage power supply fan attaches to the underside of the
printer unit chassis.

Removing the printer unit chassis

Reverse these steps to install the printer unit chassis. Ensure all wiring harnesses
are not pinched during reassembly.
98 Phaser 1235 Network Color Printer