Printer Unit Chassis (Pl 5.1.14) - Xerox 7300B - Phaser Color Laser Printer Service Manual

Printer Unit Chassis (PL 5.1.14)

1. Remove the Fuser and the Transfer Unit.
2. Remove the Image Processor Board (see pg. 6-142).
3.
Remove the Rear Cover (see pg. 6-135).
4.
Remove the Front Cover (see pg. 6-136).
5. Remove the Left Side Cover (see pg. 6-138).
6. Remove the 5 G and 2 B screws securing the Left Side Shield Plate and remove
the plate.
7. Remove the 5 G screws and the 3 B screw securing the Front Shield Plate and
remove.
8.
Remove the Multi-Purpose Tray (see pg. 6-140).
9.
Remove the 4 G and 4 B screws securing the Top Shield Plate to the Electrical
Card Cage and remove the plate.
10.
Disconnect the LED ribbon connectors located at the upper right corner of the
Engine Controller Board.
Note: Label harnesses and ribbon cables to aid in reassembly.
11. Remove all the screws securing the EMI shield (covering the ribbon cables) from
the top of the Electrical Card Cage.
12. Pull the disconnected ribbon cables through the top of the electrical card cage.
Tape the open edge of the EMI Shield to keep the cables in place.
6-156
G
G
G
Phaser 7300 Color Printer Service Manual
G
G
B
S7300-113
B
B