Feeder Drive Assembly; Removing The Feeder Control Board Cover Plate - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Feeder drive assembly

Warning Switch off the power and disconnect the power cord.
1. Remove the printer from the optional paper feeder.
2.
Remove the paper tray from the feeder.
3.
Remove the four screws securing the feeder control board cover plate.
Remove the plate.

Removing the feeder control board cover plate

4. Remove the idler roller assembly as explained on page 164.
5.
Remove the inner frame as detailed on page 166
6.
Remove the feeder clutch as shown on page 169.
7. Remove the feeder motor as shown on page 171.
8.
Remove the paper transport roll guide as shown on page 175.
9. Disconnect harness SNS2 from the feeder control board.
10.
Release the two locking tabs securing the feed roll drive gear to the feed
shaft and move the shaft to the left. Remove the gear.
11. Release the nudger roll spring attached to the right end of the feeder
drive assembly.
Service Guide 177