Removing The Harnesses From The Electrical Chassis - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

9. Remove the three screws securing the cable shield to the top chassis.
10.
Remove the harnesses from the electrical chassis.
11. Disconnect the POWER inline connector from the top cover inner frame.

Removing the harnesses from the electrical chassis

12.
Remove the rear cover as detailed in "Rear cover" on page 90.
13. Remove the screws from the metal strap attached to the left pivot arm.
Remove the strap and the metal washer from the center of the pivot
arm.
14. Remove the screw from the center of the right pivot arm.
15.
Remove the system controller board.
16. From the top of the chassis, remove the two screws holding the system
controller board's upper guide rail.
17. Through the access hole in the top of the electrical chassis, loosen (but
do not remove) the screw holding the strap to the right pivot arm.
18. Swing the metal strap up to clear it from the right pivot arm. Hold it
out of the way until the pivot arm is free.
Service Guide 101