Black Stripe In Direction Of Paper Travel - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Black stripe in direction of paper travel

1.
Do the imaging drum units
make good connection to their
power terminals?
2. Are the LED heads wiring
harnesses undamaged and
properly seated?
3. Is +3.8V (red wire) supplied to
Pin 3 of each LED head
assembly? If yes, replace the
LED head assembly.
4.
Is +3.8 V supplied to the
POWER connector pins 1, 2, 3,
4, 5, 6, 7 and 8 on the junction
board or at the 16-pin
interconnect near the top cover
hinge (under the top shield
plate). Inspect the junction
board's wiring connectors. If
the voltage is not OK, replace
the low-voltage power supply.
5.
If +32 volts supplied to the
POWER connector pins 7, 8, 9
and 10 on the engine controller
board? Inspect the wiring harnesses or replace the low-voltage power
supply.
6.
Is +32V supplied to the HVOLT connector Pin 5 of the engine board. If not
replace the engine board. (Transfer the old engine controller board's
EEPROM (lower-right corner of board) to the new engine controller board.)
7. Inspect the high-voltage wiring harnesses.
8. Replace the high voltage power supply.
Service Guide
51