Printer Unit Chassis; Disconnecting The Registration Motor In-Line Connector (Hopff) - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Printer unit chassis (and low-voltage power supply fan)
Warning Switch off the power and disconnect the power cord.
1.
Open the top cover.
2. Remove the drum/toner cartridge basket. Cover the basket in a
lightproof black bag and store in a safe place.
3. Open the front cover and inner baffle.
4.
Remove the fuser assembly as detailed on page 139.
5.
Remove the transfer belt assembly as detailed on page 132.
6. Remove the left-side cover as described in the topic "Left-side cover" on
page 88. Remove the right-side cover as described in the topic
"Right-side cover" on page 89.
7. Remove the right shield plate as described in the topic "Right shield
plate" on page 93.
8. Remove the rear shield plate; it is secured by four screws.
9.
Remove the left shield plate; it is secured by ten screws.
10.
Remove the rear cover as described in "Rear cover" on page 90.
Remove the top cover as described in the topic "Top cover" on page 87.
11.
Remove the top cover inner frame as described in the topic page 100.
Note
Make note of the harness routing before removing harnesses.
12. Remove the multi-sheet bypass feeder as described on page 127.
13.
Free harnesses from the right rear of the chassis.

Disconnecting the registration motor in-line connector (HOPFF)

Service Guide 97