Stack Full Sensor; Removing The Led Assembly Power Connector - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual
Network color printer phaser 1235 series
Hide thumbs
Also See for 1235DT - Phaser Color Solid Ink Printer:
- Brochure & specs (4 pages) ,
- Advanced features and troubleshooting manual (144 pages) ,
- Service quick reference manual (13 pages)
Table of Contents
Advertisement
Stack full sensor
Warning
Switch off the power and disconnect the power cord.
1.
Remove the top cover.
2.
Disconnect the four LED assembly power harnesses from the bottom of
the toner sensor board.
Removing the LED Assembly power connector
3.
Close the top cover inner unit.
4.
Remove the four screws securing the metal shield over the toner
cartridge sensor board.
5.
Remove the three screws securing the toner sensor board.
6.
Rotate the board up to expose the component side of the board.
7.
Disconnect the STUCK connector from the toner sensor board.
8.
Free the disconnected cable from all cable retainers.
9.
Release the four locking tabs securing the stack full sensor.
Service Guide
149
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 1235DT - Phaser Color Solid Ink Printer and is the answer not in the manual?
Questions and answers