Belt Entrance Sensor Actuator; Removing The Belt Entrance Sensor Actuator - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Belt entrance sensor actuator

Warning
Switch off the power and disconnect the power cord.
1. Remove the printer unit chassis described in the topic "Printer unit
chassis (and low-voltage power supply fan)" on page 97.
2.
Remove the Tray 1 entrance sensor actuator as described in the topic
"Tray 1 entrance sensor actuator" on page 130.
3.
Remove the entrance sensor board as described in the topic "Entrance
sensor board" on page 113.
4. From the bottom, squeeze the two locking tabs securing the belt
entrance sensor actuator.
5. Remove the actuator from the top.

Removing the belt entrance sensor actuator

Reverse these steps to install the belt entrance actuator. For reassembly, install the
entrance sensor actuator and ensure the spring arm is properly located in the
notch in the printer unit chassis.
Service Guide 131