Registration Roller Assembly A And Drive Gear - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Registration roller assembly A and drive gear

Warning Switch off the power and disconnect the power cord.
1. Open the top cover. Remove the drum/toner cartridge basket. Cover
the basket in a lightproof black bag and store in a safe place.
2.
Remove the four imaging cartridges and basket. Cover the cartridges
and store in a safe place.
3.
Remove the transfer belt unit.
4.
Open the front cover.
5. Remove the left-side cover as described in the topic "Left-side cover" on
page 88.
6. Remove the right-side cover as described in the topic "Right-side cover"
on page 89.
7.
Remove the right shield plate as described in the topic "Right shield
plate" on page 93.
8.
Remove the multi-sheet bypass feeder as described in the topic
"Multi-sheet bypass feeder" on page 127.
9. Remove the four screws securing the registration roller assembly A.
10.
Lift the roller assembly and remove.
Note
If replacing the drive gear, continue with Steps 11 and 12.
Service Guide 135