Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual page 31

Electrical specifications
Characteristic
Primary line voltages
Primary voltage frequency
range
Power consumption
Primary voltage fusing
Secondary DC voltages
RF emissions
Environmental specifications
Characteristic
Temperature
Operating
Non-operating
Storage
Humidity
Operating
Non-operating
Altitude
Operating
Non-operating
Vibration/shock
Operating
Non-Operating (vibration)
Non-operating (shock)
Acoustic Noise (operating)
18
Phaser 1235 Network Color Printer
Specification
103 to 140 VAC (115 VAC nominal)
198 to 264 VAC (220 VAC nominal)
50 (48 to 52) or 60 (58 to 62) Hz
250 watts during standby state,
1300 watts during warm-up
450 watts average reference value
45 watts during Energy Star state
110 VAC configuration – 8 and 10 Amp
220 VAC configuration – 4 and 5 Amp
Low Voltage Power Supply
+3.3 VDC
+ 5 V
+12 V
+ 32 V
+3.8 V
Both 110 and 220 VAC-configured instruments pass these
standards: FCC Part 15 Class B
VDE Class B
EN60555-2 Class A
VCCI (CISPR 22) Class B
Specification
o o o
10 to 32 C (50 to 90
o o o
0 to 32 C (32 to 90
o o
-0 to 45 C (32 to 113
Media should be acclimated 24 hours before using in the printer.
10 to 85% relative humidity, non-condensing
10 to 95% relative humidity, non-condensing
Media should be acclimated 24 hours before using in the printer.
0 to 2500 m (8,000 ft.) at 25
0 to 15000 m (50,000 ft.)
May drop any side or corner 50 mm (2 in.) without impairment of
subsequent operation.
On five mutually perpendicular axes: 0.5 g, 25-minute sweep, 5
to 200 to 5 Hz, 100 to 200 sec./sweep cycle. No resonant
frequencies below 50 Hz.
15 g, trapezoidal flared pulse, 20 msec each axis.
Standby: 35 dBa, Running: 55 dBa, Impulse: 57 dBa
High voltage Power Supply
(CH) -900 to 1.4 kV
(DB) -100 to 400/+300 V
(SB) -200 to -700 V
(TB) +1k to +7 kV
(FIX) 0 to 5 kV
o
F)
o
F)
o
F) (with supplies)
o
C