Color Registration Sensor Assembly; Removing The Color Registration Sensor Assembly - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual
Network color printer phaser 1235 series
Hide thumbs
Also See for 1235DT - Phaser Color Solid Ink Printer:
- Brochure & specs (4 pages) ,
- Advanced features and troubleshooting manual (144 pages) ,
- Service quick reference manual (13 pages)
Table of Contents
Advertisement
Color registration sensor assembly
Warning
Switch off the power and disconnect the power cord.
1.
Open the top cover.
2.
Remove the four imaging cartridges and basket. Cover the cartridges
and store in a safe place.
3.
Remove the transfer belt unit as detailed on page 132.
4.
Remove the shutter plate as described in the previous procedure
"Shutter plate" on page 156.
5.
Remove the three screws securing the color registration sensor
assembly.
6.
As you lift the assembly, carefully disconnect the two harnesses (RSNS,
LSNS, & GGU) connected to the assembly.
7.
Remove the color registration sensor assembly.
Removing the color registration sensor assembly
Reverse these steps to install the color registration sensor assembly.
Service Guide
157
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 1235DT - Phaser Color Solid Ink Printer and is the answer not in the manual?