User Function Settings - Oki OKIFAX 1050 User Manual

User Function Settings

User Function Settings
User function settings allow you to customize the general operation of your fax machine. Refer to
the User Function Settings List below to determine which settings you may need to change, then
refer to Changing Your User Function Settings (found later in this chapter) to make the change.
User Function Settings List
01 MCF (SINGLE-LOC.): This function automatically prints a Message Confirmation Report after
each single-location transmission or polling reception. Available settings are on and off.
02 MCF (MULTI-LOC.): This function automatically prints a Message Confirmation Report after
each multiple-location transmission. Available settings are on and off.
03 SENDER ID: This function controls the printing of your fax machines Sender ID on the faxes you
send. When turned on, your fax machines Sender ID will be printed on each page slightly outside
the image area of your document. When turned off, your fax machines Sender ID will not be
printed.
Warning: Turning off your sender ID may be illegal. For more information, refer to the FCC
Telephone Consumer Protection Act statement in the beginning of this manual.
04 MONITOR VOLUME: This function sets the volume your fax machine uses for telephone line
monitoring sounds during and after dialing. Available settings are low, high and off.
05 REMOTE DIAG.: The remote diagnostics feature allows a service person to remotely dial and
service your fax machine. Available settings are on and off.
06 CLOSED NETWORK: This function allows you to program your fax machine to refuse to receive
faxes from or transmit faxes to locations whose telephone numbers have not been programmed
into your fax machines One Touch keys or Auto Dial numbers. Using this function, you can set up
a closed network of fax machines. If you do not want your fax machine to transmit faxes to or
receive faxes from locations outside your network, select T/R. If you only want your fax machine
to refuse to receive faxes from outside your network, select RX. Available settings are OFF, T/R
and RX.
07 TX MODE DEFAULT: This function allows you to change your fax machines default type of
original and transmit resolution settings. By default, your fax machine is set to use the STD and
NORMAL settings. If you are constantly sending faxes which require some other combination of
transmission modes, use this function setting to change the default transmission modes to any
other combination of settings. While you are programming, the new default combinations will
appear on the LEDs above the Transmit Resolution/ Yes < or Type of Original/No > keys.
08 T/F TIMER PROG.: When set to the telephone/fax answering mode, your fax machine
automatically distinguishes between incoming voice and fax calls. If the incoming call is a voice
call, your fax machine will ring to tell you to pick up the handset. If you do not answer, your fax
machine automatically switches back to facsimile mode to allow the calling party to send a fax.
The T/F TIMER function controls how long your fax machine waits before switching back to fax
mode. Available settings are 20 seconds or 35 seconds.
Tip:
In order for the TAD interface to function properly, the T/F Timer must be set for the factory
default of 35 seconds.
OF1050 Users Guide(96-01-30)