Sending A Fax To A Single Location - Oki OKIFAX 1050 User Manual

Sending a Fax to a Single Location

Sending a Fax to a Single Location
1 Load your documents.
2 Select a location. Refer to the instructions below. Document Type Contrast to Use
Documents with normal contrast NORMAL
Documents which are too light LIGHT
Documents which are too dark DARK
To Dial Using
A One Touch key
An Auto Dial number Press the Auto Dial key, then enter the two digit Auto Dial
The numeric keypad Dial as you would on a normal telephone. If you make a
An external telephone Pick up the handset of your external telephone and dial the number
3 When dialing manually on the numeric keypad or on an external telephone, press the Start key to
begin the transmission. Refer to the table below to understand some of the messages you may
see during a typical fax transmission.
Message
(location)
DIALING
CALLING
SENDING
RESULT = OK
COMMUN. ERROR
Refer to the chapter on Problem Solving for assistance (
OF1050 Users Guide(96-01-30)
Do This
Press the One Touch key.
number on the numeric keypad.
mistake, press the Yes < key to go back and re-enter the number.
of the machine you wish to transmit to. If the receiving fax machine is in
automatic reception mode, you will hear a high-pitched tone. Press the
Start key to begin transmitting. If a person answers the phone, ask them to
press the Start key on their fax machine. When you hear the high-pitched
tone, press the Start key to begin transmitting.
Explanation
The remote locations Personal ID, TSI/CSI, Location ID or the telephone
number you entered will identify the location during transmission.
Your fax machine is dialing the number.
The line is ringing.
Your fax machine is sending the message.
The fax was sent successfully.
If you see this or another error message, a problem occurred during
the communication. Try resending the fax.
).