Service Function Settings - Oki OKIFAX 1050 User Manual

Service Function Settings

Service Function Settings
Service function settings in many cases greatly change the way your fax machine operates. To
change any of these settings, contact your dealer.
Service Function Settings List
ERR REPORT (MCF): This function automatically prints a Message Confirmation Report each time
an error occurs during a transmission or polling reception operation.
LONG DOC. SCAN: Normally, your fax machine will not scan documents longer than 14" (356 mm).
When this function is on, your fax machine will scan and transmit documents of any length for up
to one hour.
MDY/DMY: This function controls how your fax machine displays and prints the date
(month/day/year or day/month/year).
TIME/DATE PRINT: This function controls how your local time and date are printed on the fax
messages which you receive. Your fax machine can be set to not print the time and date, to print
it at the top the first page only, or to print it at the top of every page.
TSI PRINT: When this function is on, the telephone number of the fax machine sending you a fax
message is printed at the top of each page of the messages you receive.
NO TONER MEM. RX: When this function is turned on, your fax machine will automatically receive
messages in memory when it is low on toner.
TAD MODE: This function allows an answering machine to operate on the same line as your fax
machine.
TEL/FAX SW: When this function is on, the telephone/ fax [T/F] answering mode is available, which
allows your fax machine to automatically distinguish between incoming voice and fax telephone
calls.
OF1050 Users Guide(96-01-30)