Ilom-To-Alom Cmt Command Reference - Fujitsu SPARC Enterprise T5440 Service Manual

Note – In the ILOM shell there is no notification when the system is actually
powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.
ILOM-to-ALOM CMT Command
Reference
TABLE: ALOM CMT Parameters and POST Modes on page 56
commands for servicing a server. For descriptions of all ALOM CMT commands,
issue the help command or refer to the following documents:
Integrated Lights Out Manager 3.0 Concepts Guide
■
Integrated Lights Out Manager 3.0 Supplement for SPARC Enterprise T5440 Server
■
Service-Related Commands
TABLE:
ILOM Command
help [command]
set /HOST/send_break_action
true
set
/SYS/component/clear_fault_a
ction true
start /SP/console
ALOM CMT Command
help [command]
break [-y][-c][-D]
• -y skips the confirmation
question.
• -c executes a console command
after the break command
completes.
• -D forces a core dump of the
Solaris OS.
clearfault UUID
console [-f]
• -f forces the console to have read
and write capabilities.
describes the typical
Description
Displays a list of all available
commands with syntax and
descriptions. Specifying a command
name as an option displays help for
that command.
Takes the host server from the OS to
either kmdb or OpenBoot PROM
(equivalent to a Stop-A), depending
on the mode Solaris software was
booted.
Manually clears host-detected
faults. The UUID is the unique fault
ID of the fault to be cleared.
Connects you to the host system.
Managing Faults 53