Fujitsu SPARC Enterprise T5440 Service Manual page 80

Service-Related Commands (Continued)
TABLE:
ILOM Command
show /SP/console/history
set
/HOST/bootmode/value[normal|re
set_nvram|bootscript=string]
stop/SYS; start/SYS
stop/SYS
start/SYS
54 SPARC Enterprise T5440 Server Service Manual • July 2009
ALOM CMT Command
consolehistory [-b lines|-e lines|-v]
[-g lines] [boot|run]
The following options enable you to
specify how the output is
displayed:
• -g lines specifies the number of
lines to display before pausing.
• -e lines displays n lines from the
end of the buffer.
• -b lines displays n lines from the
beginning of the buffer.
• -v displays the entire buffer.
• boot|run specifies the log to
display (run is the default log).
bootmode value
[normal|reset_nvram|
bootscript=string]
powercycle [-f]
The -f option forces an immediate
poweroff. Otherwise the command
attempts a graceful shutdown.
poweroff [-y] [-f]
• -y enables you to skip the
confirmation question.
• -f forces an immediate
shutdown.
poweron [-c]
• -c executes a console command
after completion of the poweron
command.
Description
Displays the contents of the
system's console buffer.
Enables control of the firmware
during system initialization with
the following options:
• normal is the default boot mode.
• reset_nvram resets OpenBoot
PROM parameters to their
default values.
• bootscript=string enables the
passing of a string to the boot
command.
Performs a poweroff followed by
poweron.
Powers off the host server.
Powers on the host server.