2. Slide the module down into its slot.
Installing a CMP/Memory Module
FIGURE:
3. Rotate the ejector levers down to secure the module into place.
Next Steps
"Install the Top Cover" on page 150
■
"Slide the Server Into the Rack" on page 151
■
"Power On the Server" on page 153
■
▼ Add a CMP/Memory Module
Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 66
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 69
■
"Remove the Top Cover" on page 69
■
Do the following :
1. Identify the correct slot for installation.
"Safety Information" on page
63.
59.
Servicing Customer-Replaceable Units
"Powering
101