Servicing The Hard Drive Backplane; Remove The Hard Drive Backplane - Fujitsu SPARC Enterprise T5440 Service Manual

"Servicing the Fan Tray Carriage" on page 129
■

▼ Remove the Hard Drive Backplane

Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 66
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 69
■
"Remove the Top Cover" on page 69
■
"Remove a Hard Drive" on page 77
■
Note – You must remove all four hard drives from the server. Note the location of
each hard drive you remove. You must re-install each hard drive in the correct bay.
"Remove a Fan Tray" on page 83
■
Note – You must remove all four fan trays.
"Remove the Fan Tray Carriage" on page 129
■
Do the following:
1. Remove the flex cable retainer.
Loosen the captive No.2 Phillips screw and lift the retainer up and out of the
chassis.
2. Unplug the cable from the hard drive backplane.
3. Loosen the three captive No. 2 Phillips screws.
132 SPARC Enterprise T5440 Server Service Manual • July 2009
"Safety Information" on page
63.
59.
"Powering