▼ Remove the Front Bezel
Before you begin, complete these tasks:
Read the section,
■
If you are performing additional service procedures, power off the server, using
■
one of the methods described in the section,
page
"Extend the Server to the Maintenance Position" on page 66
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 69
■
Do the following :
1. Grasp the front bezel on the left and right sides.
2. Pull the bezel off of the front of the chassis.
The bezel is secured with three snap-in posts.
116
SPARC Enterprise T5440 Server Service Manual • July 2009
"Safety Information" on page
63.
59.
"Powering Off the System" on