Fujitsu SPARC Enterprise T5440 Service Manual page 82

Service-Related Commands (Continued)
TABLE:
ILOM Command
(No ILOM equivalent.)
show /SYS/keyswitch_state
show /SYS/LOCATE
show /SP/logs/event/list
show /SYS
TABLE: ALOM CMT Parameters and POST Modes on page 56
combinations of ALOM CMT variables and associated POST modes.
ALOM CMT Parameters and POST Modes
TABLE:
Normal Diagnostic Mode
Parameter (Default Settings)
diag mode normal
keyswitch_state normal
diag_level max
56 SPARC Enterprise T5440 Server Service Manual • July 2009
ALOM CMT Command
showfru [-g lines] [-s | -d] [FRU]
• -g lines specifies the number of
lines to display before pausing
the output to the screen.
• -s displays static information
about system FRUs (defaults to
all FRUs, unless one is specified).
• -d displays dynamic information
about system FRUs (defaults to
all FRUs, unless one is specified).
See "Display Individual
Component Information With the
ILOM show Command" on
page 25.
showkeyswitch
showlocator
showlogs [-b lines | -e lines |
-v] [-g lines] [-p
logtype[r|p]]]
showplatform [-v]
No POST Execution
Off
normal
N/a
Description
Displays information about the
FRUs in the server.
Displays the status of the virtual
keyswitch.
Displays the current state of the
Locator LED as either on or off.
Displays the history of all events
logged in the service processor
event buffers (in RAM or the
persistent buffers).
Displays information about the
operating state of the host system,
the system serial number, and
whether the hardware is providing
service.
shows typical
Diagnostic Service Keyswitch Diagnostic
Mode Preset Values
service normal
normal diag
max max