Change Post Parameters - Fujitsu SPARC Enterprise T5440 Service Manual

ILOM Parameters Used for POST Configuration (Continued)
TABLE:
Parameter
diag_trigger
diag_verbosity
Related Information
"Diagnostic Flowchart" on page 11
■
"Change POST Parameters" on page 28
■
"Run POST in Maximum Mode" on page 28
■
"Detecting Faults Using POST" on page 42
■
"Clear Faults Detected During POST" on page 48
■
SPARC Enterprise T5440 Server Installation and Setup Guide
■
SPARC Enterprise T5440 Server Administration Guide
■

▼ Change POST Parameters

1. Access the ILOM prompt.
See "Connecting to the Service Processor" on page
Values Description
Does not run POST on reset.
none
Runs POST upon user initiated resets.
user_reset
Only runs POST for the first power on. This
power_on_reset
option is the default.
Runs POST if fatal errors are detected.
error_reset
Runs POST after any reset.
all_resets
No POST output is displayed.
none
POST output displays functional tests with a
min
banner and pinwheel.
POST output displays all test and informational
normal
messages.
POST displays all test, informational, and some
max
debugging messages.
22.
Managing Faults 27