Ilom-To-Alom Cmt Command Reference - Fujitsu SPARC Enterprise T5440 Service Manual

1. At the -> prompt, set the component_state property to Enabled.
-> set /SYS/MB/CPU0/CMP0/BR1/CH0/D0 component_state=Enabled
2. Reset the server so that the ASR command takes effect.
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
Note – In the ILOM shell there is no notification when the system is actually
powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.
ILOM-to-ALOM CMT Command
Reference
The following table describes the typical commands for servicing a server. For
descriptions of all ALOM CMT commands, issue the help command or refer to the
following documents:
Integrated Lights Out Manager 3.0 Concepts Guide
■
58 SPARC Enterprise T5440 Server Service Manual • June 2011