Connecting To The Service Processor - Fujitsu SPARC Enterprise T5440 Service Manual

Note – You can use the FB-DIMM DIAG buttons on the CMP module and memory
module to identify faulty FB-DIMMs. See
page
Once you identify which FB-DIMMs you want to replace, see
on page 104
the instructions in that section to clear the faults and enable the replaced FB-DIMMs.
Related Information
"Controlling How POST Runs" on page 26
■
"Displaying FRU Information with ILOM" on page 24
■
"Detecting Faults" on page 30
■
"Servicing FB-DIMMs" on page 104
■

Connecting to the Service Processor

Before you can run ILOM commands, you must connect to the service processor.
There are several ways to connect to the service processor.
Topic
Connect an ASCII terminal directly to the
serial management port.
Use the ssh command to connect to service
processor through an Ethernet connection
on the network management port.
Switch from the system console to the
service processor
Switch from the service processor to the
system console
Related Information
"Diagnostic Flowchart" on page 11
■
22 SPARC Enterprise T5440 Server Service Manual • July 2009
113.
for FB-DIMM removal and replacement instructions. You must perform
"FB-DIMM Fault Button Locations" on
"Servicing FB-DIMMs"
Links
SPARC Enterprise T5440 Server Installation
and Setup Guide
SPARC Enterprise T5440 Server Installation
and Setup Guide
"Switch From the System Console to the
Service Processor (ILOM or ALOM CMT
Compatibility Shell)" on page 23
"Switch From ILOM to the System Console"
on page 23
"Switch From the ALOM CMT
Compatibility Shell to the System Console"
on page 24