Next Steps
"Install the Front Bezel" on page 117
■
"Install the Top Cover" on page 150
■
"Slide the Server Into the Rack" on page 151
■
"Power On the Server" on page 153
■
Servicing the Service Processor
The service processor module contains the service processor firmware, IDPROM, and
system battery.
Related Information
"Servicing the IDPROM" on page 123
■
"Servicing the Battery" on page 125
■
▼ Remove the Service Processor
Before you begin, complete these tasks:
Read the section,
■
Power off the server using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 66
■
"Disconnect Power Cords From the Server" on page 65
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 69
■
"Remove the Top Cover" on page 69
■
Do the following:
1. Ensure that the power cords are disconnected from the server.
2. Loosen the two captive No. 2 Phillips screws securing the service processor to
the motherboard.
120
SPARC Enterprise T5440 Server Service Manual • July 2009
"Safety Information" on page
63.
59.
"Powering