Install A Fan Tray; Fan Tray Device Identifiers; Fan Tray Fault Led - Fujitsu SPARC Enterprise T5440 Service Manual

▼ Install a Fan Tray

1. Slide each fan tray into its bay until it locks into place.
Ensure that the fan tray is oriented correctly. Airflow in the system is from front to
back.
2. Verify proper fan tray operation.
See
Next Steps
If you are replacing the fan trays after performing another service procedure,
complete these steps.
"Slide the Server Into the Rack" on page 151
■
"Power On the Server" on page 153
■

Fan Tray Device Identifiers

TABLE: Fan Tray Device Identifiers on page 84
the fan trays in the server.
TABLE:
Device
FT0
FT1
FT2
FT3
Related Information
"Managing Faults" on page 9
■
"Hot-Pluggable and Hot-Swappable Devices" on page 72
■
"Fan Tray Fault LED" on page 84
■

Fan Tray Fault LED

Each fan tray contains a Fault LED that is located on the top panel of the server. The
LED is visible when you slide the server partially out of the rack.
84 SPARC Enterprise T5440 Server Service Manual • July 2009
"Fan Tray Fault LED" on page
Fan Tray Device Identifiers
Device Identifier
/SYS/MB/FT0
/SYS/MB/FT1
/SYS/MB/FT2
/SYS/MB/FT3
84.
describes the FRU device names for