5. Grasp the latch and pull the drive out of the drive slot.
Sample Ap_id Output
CODE EXAMPLE:
Ap_id
c0
c0::dsk/d1t0d0
c0::dsk/d1t1d0
usb0/1
usb0/2
usb0/3
usb1/1
usb1/2
usb1/3
usb2/1
usb2/2
usb2/3
usb2/4
usb2/5
usb2/6
usb2/7
usb2/8
----------------------------
▼ Install a Hard Drive (Hot-Plug)
Installing a hard drive into the SPARC Enterprise T5440 servers is a two-step process.
You must first install a hard drive into the desired drive slot. Then you must
configure that drive to the server.
Perform the following process to install a hard drive.
1. If necessary, remove the blank panel from the chassis.
Note – The server might have up to three blank panels covering unoccupied drive
slots.
2. Align the replacement drive to the drive slot.
Hard drives are physically addressed according to the slot in which they are
installed. If you removed an existing hard drive from a slot in the server, you must
install the replacement drive in the same slot as the drive that was removed.
3. Slide the drive into the drive slot until it is fully seated.
Type
Receptacle
scsi-bus
connected
disk
connected
disk
connected
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
unknown
empty
Occupant
configured
configured
configured
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
Servicing Customer-Replaceable Units
Condition
unknown
unknown
unknown
75