Removing the IDPROM
FIGURE:
2. Place the IDPROM on an antistatic mat.
▼ Install the IDPROM
Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 66
■
"Disconnect Power Cords From the Server" on page 65
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 69
■
"Remove the Top Cover" on page 69
■
"Remove the Service Processor" on page 120
■
124
SPARC Enterprise T5440 Server Service Manual • July 2009
"Safety Information" on page
63.
59.
"Powering