Changing Post Parameters - Fujitsu SPARC Enterprise T2000 Service Manual

TABLE 3-10
POST modes.
ALOM CMT Parameters and POST Modes
TABLE 3-10
Normal Diagnostic Mode
Parameter (Default Settings)
diag_mode normal
*
setkeyswitch normal
\
diag_level min
diag_trigger power-on-reset
error-reset
diag_verbosity normal
Description of POST This is the default POST
execution configuration. This
configuration tests the
system thoroughly, and
suppresses some of the
detailed POST output.
* The setkeyswitch parameter, when set to diag, overrides all the other ALOM CMT POST variables.
\ Earlier versions of firmware have max as the default setting for the POST diag_level variable. To set the default to min, use the
ALOM CMT command, setsc diag_level min
3.4.2

Changing POST Parameters

1. Access the ALOM CMT sc> prompt:
At the console, issue the #. key sequence:
#.
2. Use the ALOM CMT sc> prompt to change the POST parameters.
Refer to
The setkeyswitch parameter sets the virtual keyswitch, so it does not use the
setsc command. For example, to change the POST parameters using the
setkeyswitch command, enter the following:
sc> setkeyswitch diag
3-30 SPARC Enterprise T2000 Server Service Manual • April 2007
shows typical combinations of ALOM CMT variables and associated
No POST Execution
off
normal
n/a
none
n/a
POST does not
run, resulting in
quick system
initialization, but
this is not a
suggested
configuration.
for a list of ALOM CMT POST parameters and their values.
TABLE 3-9
Keyswitch
Diagnostic Service Diagnostic Preset
Mode Values
service normal
normal diag
max max
all-resets all-resets
max max
POST runs the POST runs the
full spectrum of full spectrum of
tests with the tests with the
maximum output maximum output
displayed. displayed.