Install A Hard Drive (Hot-Plug) - Fujitsu SPARC Enterprise T5440 Service Manual

Sample Ap_id Output
EXAMPLE:
Ap_id
c0
c0::dsk/d1t0d0
c0::dsk/d1t1d0
usb0/1
usb0/2
usb0/3
usb1/1
usb1/2
usb1/3
usb2/1
usb2/2
usb2/3
usb2/4
usb2/5
usb2/6
usb2/7
usb2/8
----------------------------

▼ Install a Hard Drive (Hot-Plug)

Installing a hard drive into the server is a two-step process. You must first install a
hard drive into the desired drive slot. Then you must configure that drive to the
server.
Perform the following process to install a hard drive.
1. If necessary, remove the blank panel from the chassis.
Note – The server might have up to three blank panels covering unoccupied drive
slots.
2. Align the replacement drive to the drive slot.
Hard drives are physically addressed according to the slot in which they are
installed. If you removed an existing hard drive from a slot in the server, you must
install the replacement drive in the same slot as the drive that was removed.
3. Slide the drive into the drive slot until it is fully seated.
Type Receptacle
scsi-bus connected
disk connected
disk connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
Occupant
configured
configured
configured
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
Servicing Customer-Replaceable Units
Condition
unknown
unknown
unknown
79