Options; High-Speed Processing Version Als 380 Hs; Serial Interface; Roll Diameter Control - Avery Dennison ALS 380 Operating Manual

2 E
QUIPMENT DESCRIPTION
2.1 O
VERVIEW

Options

2.1.5
High-speed processing version
ALS 380 HS
– Allows dispensing speeds up to 100 m/min
– Available in all of the above-mentioned design ver-
sions.

Serial interface

– Almost all of the setting values can be read out and
modified on an external device, the machine status
can be queried, and the machine can be controlled
via this interface.

Roll diameter control

– A sensor at the unwind unit monitors the diameter of
the label roll and, along with it, the supply of labels.
– The sensor sends a signal when the diameter of the
label roll reaches a set value.
– This sensor is required if two labellers are operating
in tandem mode (see chapter Operation - Activation
and shut-down, Tandem operation)

Adjustable dispensing edge

– The position of the dispenser head can be adjusted
vertically.
– This allows adapting the position of the dispensing
edge to changing products.
– The machine does not have to be moved to adjust
the dispensing edge. The labelling head of the ma-
chine does not have to be released.

Printer

– Inkjet or heat transfer printer at the dispenser head.

Applicator

If direct labelling from the dispensing edge is not possi-
ble, the labeller can be equipped with an applicator.
Various kinds of applicators are available depending on
the customer's needs.
15
ALS
380