Installation; Planning The Installation; Site Log; Network Information - Patton SmartNode SN4170 User Manual

SmartNode 4170 User Manual

Planning the Installation

Before installing the SmartNode device, the following tasks should be completed:
• Create a network diagram (see section
• Gather IP related information (see section
• Install the hardware and software needed to configure the SmartNode. (See section
page 24)
• Verify power source reliability (see section
When you finish preparing for SmartNode installation, go to section
Gateway" on page 24 to install the device.

Site log

Patton recommends that you maintain a site log to record all actions relevant to the system, if you do not
already keep such a log. Site log entries should include information such as listed in Table 4.
Entry

Installation

Upgrades and maintenance
Configuration changes
Maintenance
Comments
Software

Network information

Network connection considerations that you should take into account for planning are described for several
types of network interfaces in the following sections.

Network Diagram

Draw a network overview diagram that displays all neighboring IP nodes, connected elements and telephony
components.

IP related information

Before you can set up the basic IP connectivity for your SmartNode SN4170 you should have the following
information:
• IP addresses used for the Ethernet port
• Subnet mask used for the Ethernet port

Planning the Installation

"Network information"

"IP related information"

"Power source"
Table 4. Sample site log entries
Make a copy of the installation checklist and insert it into the site log
Use the site log to record ongoing maintenance and expansion history
Record all changes and the reasons for them
Schedules, requirements, and procedures performed
Changes and updates to Trinity software
3 • SmartNode Installation
on page 23)
on page 23 for more information)
on page 24).
"Installing the Patton SmartNode VoIP
Description
Notes, and problems
"Software tools" on
23