Encoder Rear Panel; Encoder Rear Panel Ports - Patton FiberPlex FPX6000 Series User Manual

FiberPlex FPX6000 Series User Manual
LEDs/Ports
HDCP
Serial
IR (Top)
IR (Bottom)
USB OTG
USB 1
USB 2

Encoder rear panel

Rear panel ports of the FPX6000 Series Encoder are shown in
LEDs/Ports
Monitor Out
HDMI Input
ETH2
ETH1 (PoE)
PSU
Encoder rear panel
Table 1. Front panel ports and LED descriptions (Continued)
Solid Green: Non-HDCP unprotected video sync or source detected
Blinking Green: HDCP protected content detected
Solid Red: Invalid non-HDCP video sync or source
Blinking Red: Failed HDCP negotiation
Blinking Amber: HDCP negotiation in progress
Off: No power
RJ45 port for PTZ control input (RS422/VISCA)
Output to emitter: 3mm for infrared control over IP
Input from receiver: 3mm for infrared control over IP
Mini-USB OTG port for keyboard and mouse over IP
USB 2.0 Type A connector for keyboard and mouse over IP
USB 2.0 Type A connector for keyboard and mouse over IP
Figure 5. Encoder rear panel ports
Table 2. Encoder rear panel ports descriptions
Video thru from HDMI Input
HDMI 2.0/1.4b Video Source Input
Used for Daisy Chaining devices
Dante Network (Primary Connection) and PoE input
48 VDC at 30W
Description
figure 5 and described in
Description
2 • Hardware Description
table 1.
17