LG CodePlus PIVD100R Installation & Setup Manual page 51

Configuration Options via Command Line (Cont.)
Access the IP Output Configuration Menu
1. At the Setup Command > prompt, type ipout and press Enter.
2. At the IP Output Command > prompt, either:
• Press Enter to display the IP Output Configuration Menu (see example below).
• Type the desired command and press Enter.
----------------------------
IP Output Configuration Menu
----------------------------
display Display output IP configuration
set Configure output IP channel
fill Fill IP configuration with autoincrement IP
apply Apply the new IP configuration
exit Return to the Setup Menu
IP Output Command >
Display Output IP Configuration
1. At the IP Output Command > prompt, type display and press Enter to view the
current output configuration, for example:
N IP Address
--- -------------
1-1 227.0.0.0
2-1 227.0.0.2
3-1 227.0.0.4
4-1 227.0.0.6
5-1 227.0.0.8
6-1 227.0.0.10
7-1 227.0.0.11
8-1 227.0.0.12
2. At the IP Output Command > prompt, type exit and press Enter to return to the Setup
Menu when you are finished reviewing the display.
Manually Configure Output IP Channels
This option enables you to specify the multicast IP address and port number for each program.
Each program must be assigned a unique IPv4 multicast address. See "Channel Assignments
for IP Output" on page 9, and/or check with your service representative, if necessary.
Note: If you wish to set a base multicast IP address and have the system auto-increment the
remaining program data, use the "fill" option described below.
1. At the IP Output Command > prompt, type set and press Enter.
206-4202
Port
----
1234
1234
1234
1234
1234
1234
1234
1234
(Continued on next page)
51