Stb Menu Commands - LG CodePlus PIVD100R Installation & Setup Manual

Configuration Options via Command Line (Cont.)

STB Menu Commands

The following subsections describe how to access and use the STB Menu commands.
Access the STB Menu
1. Log in to the PIVD100R as described on page 37.
2. At the Command > prompt, type stb and press Enter.
3. At the Enter STB number > prompt, type the number of the PIVD100R X-Port
connected to the STB for which you wish to view/modify configuration. Then, press Enter.
The system identifies the current STB and then displays an STB command prompt, for
example:
Current STB: STB-1
STB-1 Command >
4. At the STB Command > prompt, either:
• Press Enter to display the STB Menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the STB Command > prompt to display the STB
Menu.
Example: STB Menu
---------
STB Menu
---------
stb Change STB
info STB info
monitor System monitor
channel Set channel
output Output slot
on Turn STB On
off Turn STB Off (Standby)
update Schedule STB software update
reset Reset STB
exit Return to the main menu
STB-1 Command >
40
206-4202