LG CodePlus PIVD100R Installation & Setup Manual page 46

Configuration Options via Command Line (Cont.)
Example: Setup Menu
----------
Setup Menu
----------
info System information
monitor System monitor
type Set STB type
omode Set output mode
setip Control port IP configuration menu
rf RF output configuration
ipout IP output configuration menu
tz Timezone setup
time Time setup
pwd Change password
exit Return to the main menu
reset System reset
Setup Command >
View System Information
This option is also available from the PIVD100R Main Menu.
At the Setup Command > prompt, type info and press Enter.
The System Information display identifies important information about the PIVD100R,
including the unit serial number, software version, hardware ID (firmware version), Control
Port MAC and IP addresses, and output configuration. See sample display under the "View
System Information" section on page 38.
It is recommended that you record this information for future reference. If you find it necessary
to call customer service or engineering support, please have this information available.
Monitor the System
This option enables you to view static or dynamic system streaming data and is also available
from the PIVD100R Main Menu and the STB Menu.
At the Setup Command > prompt, either:
• Type monitor and press Enter to display the current system data (see sample displays
under the "Monitor the System" section on page 38).
• To monitor streaming data in real time, type monitor and the number of seconds before
the data refreshes. Then, press Enter. For example, to refresh the data every second, type
monitor 1 and press Enter.
When you are finished monitoring streaming data, press Enter to stop the system monitor
and return to the Setup Command > prompt.
46
206-4202