LG CodePlus PIVD100R Installation & Setup Manual page 48

Configuration Options via Command Line (Cont.)
Configure the Control Port
1. At the Setup Command > prompt, type setip and press Enter.
The system displays an overview of the current TCP/IP network configuration followed by
the Network Configuration Menu, for example:
Current Network Configuration
Interface controller port
Host name:
Using DHCP:
DNS servers
Primary DNS:
Secondary DNS:
--------------------------
Network Configuration Menu
--------------------------
ip Configure Control Port IP
dns Configure DNS
exit Exit network configuration
Choose item to modify >
2. Either:
• Continue with step 3 for information on modifying the IP configuration of the Control Port.
• Go to step 8 for information on modifying the DNS configuration.
• To exit the Network Configuration Menu without modifying any settings, type exit at the
Network Configuration Menu > prompt.
3. Type ip and press Enter to modify the configuration of the Control Port.
4. At the Host name [pivd100r]: prompt, either press Enter to accept the default value in
square brackets, or type a new host name and then press Enter.
5. At the Using DHCP (Y/N) [Y]: prompt, type y if the PIVD100R uses DHCP, or type n to
specify the network IP addresses. Then, press Enter.
6. If the PIVD100R is NOT using DHCP, type the information requested at each of the following
prompts. Press Enter after each entry.
This host IP address []:
Network mask []:
Gateway IP address []:
48
pivd100r
YES
68.94.156.1
68.94.157.1
(Type the host IP address in the format xxx.xxx.xxx.xxx.)
(Type the netmask in the format xxx.xxx.xxx.xxx.)
(Type the IP address of the default gateway in the format xxx.xxx.xxx.xxx.)
(Continued on next page)
206-4202