LG CodePlus PIVD100R Installation & Setup Manual page 49

Configuration Options via Command Line (Cont.)
(Continued from previous page)
7. Once you enter the gateway IP address, the system will redisplay the Network Configuration
Menu.
• To modify the DNS configuration, continue with step 8.
• If no additional network configuration is required, go to step 9.
8. To change the DNS configuration, type dns and press Enter.
At each of the following prompts, type the information requested. Press Enter after each
entry.
Configuring DNS
Primary DNS IP address []:
Secondary DNS IP address []:
Once you enter the secondary DNS IP address, the system will redisplay the Network
Configuration Menu. You can select another option to modify (see previous steps) or you
can exit as described below.
9. When you are finished with network configuration, type exit at the Network Configuration
Menu > prompt. The system will display an overview of the new network configuration
and then prompt for confirmation to save the changes, for example:
New Network Configuration
Interface controller port
Host name:
Using DHCP:
Host IP address:
Network mask:
Gateway IP address: 136.166.60.1
DNS servers
Primary DNS:
Secondary DNS:
Do you want to save the new configuration? (Y/N):
10. Type y or n and press Enter, as appropriate.
If you opt NOT to save the new configuration, the system will return immediately to the
Setup Command > prompt. Otherwise, the system will confirm the configuration updates
and prompt you to reset the system:
New configuration has been saved. Please restart the system.
11. If you are ready to reset the system immediately, at the Setup Command > prompt, type
reset and press Enter (see "Reset the System" on page 56 for further information).
Note: If you intend to modify additional configuration settings during the current session,
you may wait until all changes are complete before you reset the system.
206-4202
pivd100r
NO
136.166.60.92
255.255.255.0
68.94.156.2
68.94.157.2
49