Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Schedule an STB Software Update (ViP 222 or ViP 222k STBs Only)
This option is available only for ViP 222 and ViP 222k STBs. The STB Software Update
feature enables the STB to check for and download software updates on a one-time, user-
defined basis. An STB Update should periodically be scheduled in conjunction with software
updates from the satellite service provider.
Note: If you intend to schedule an STB software update, make sure the time is set
on the PIVD100R. See "Set the Time Zone" and "Set the Date and Time" on pages
53 to 55 for further information.
Note: At the time an update is scheduled to begin, the PIVD100R will switch the
STB(s) to standby in order to enable it/them to download the update. When the 30
minutes allowed for the update window is over, the PIVD100R will power the STB(s)
back ON; however, note that it may take up to 10 minutes for streaming to resume.
Contact your service provider for further information.
1. At the STB Command > prompt, type update and press Enter.
2. At the Enable STB software update? [y/n]: prompt, either:
• Type y and press Enter to enable an STB software update. The system will initiate a
series of prompts that enable you to configure the date and time parameters for the
update. Continue with step 3.
• Type n and press Enter to disable the STB software update. At the Also disable for
all other STBs? [y/n]: prompt, either:
- Type y and press Enter to disable a scheduled STB software update on all STBs
connected to the PIVD100R, or
- Type n and press Enter to disable a scheduled STB software update on the current
STB only.
The system will display confirmation of your setting, for example:
STB-1 SW Update: not scheduled
3. At each of the following prompts, type the year, month, and day, respectively, on which you
wish to schedule the STB software update. Note that all three of these fields require
numerical values. Press Enter after each entry.
If applicable, you can also press Enter at each prompt to accept the default value in
square brackets.
Enter year [2012]>
Enter new month [2]>
Enter new day [22]>
44
(Continued on next page)
206-4202
Advertisement
Table of Contents
Troubleshooting
