LG CodePlus PIVD100R Installation & Setup Manual page 29

Select the STB Type
1. In the STB Type section of the System Setup screen, click the radio button at the left of the
appropriate service provider for your system, and then click on the Set button.
If you successfully changed the STB type, the system will display
at the bottom of the System Information display. The System Information display will also
show the new STB type.
2. Click on the Reset button in the System Reset section of the System Setup screen if you
are ready to reset the system immediately (see "Reset the System" on page 32 for further
information).
Note: If you intend to modify additional configuration settings during the current session,
you may wait until all changes are complete before you reset the system.
Control Port Configuration
In the IP Configuration section of the System Setup screen, you can modify the Control Port IP
configuration as required.
1. Select the appropriate DHCP Mode—Enable (default) or Disable—by clicking the radio
button at the left of the desired option.
Note: If DHCP is enabled, the server assigns an IP address to the PIVD100R, and only the
Hostname field will be editable. All other fields will be inaccessible/grayed out.
2. If desired, modify the name of the host in the Hostname field.
3. If DHCP is disabled, specify the host IP address, the subnet mask, the default gateway IP
address, the primary DNS IP address, and the secondary DNS IP address in the fields
provided. Type each in the format xxx.xxx.xxx.xxx.
4. When you have completed the fields as required, click on the Set button below the
Secondary DNS IP Address field.
If you successfully changed the IP configuration of the Control Port, the system will display
Information display will also show the new Control Port IP address, if applicable.
5. Click on the Reset button in the System Reset section of the System Setup screen if you
are ready to reset the system immediately (see "Reset the System" on page 32 for further
information).
Note: If you intend to modify additional configuration settings during the current session,
you may wait until all changes are complete before you reset the system.
206-4202
Configuration Options via GUI (Cont.)
at the bottom of the System Information display. The System
29