When "Sw" = Moment, the speaker is rotating. It stops only when
you press the pedal or operate the joystick.
Rotation will occur when the value of the modulation
source is less than 64, and will stop when the value is 64 or
This parameter sets how the rotation speed (slow and fast) is
switched via the modulation source.
When "Sw" = Toggle, the speed is switched between slow and
fast each time you press the pedal or operate the joystick.
Slow/fast will alternate each time the value of the modula-
tion source exceeds 64.
When "Sw" = Moment, the speed is usually slow. It becomes fast
only when you press the pedal or operate the joystick.
When a value for the modulation source is less than 64,
"slow" speed is selected, and when the value is 64 or higher,
"fast" is selected.
c: Manual Speed Ctrl
If you wish to control the speaker rotation speed manually, not
switching between Slow and Fast, select the modulation source in
the "Manual Speed Ctrl" ﬁeld. If manual control is not necessary,
set this ﬁeld to Off.
d: Horn Acceleration, e: Rotor Acceleration
On a real rotary speaker, the rotation speed is accelerated or decel-
erated gradually after you switch the speed. The "Horn Accelera-
tion" parameter sets the speed at which the rotation is accelerated
g: Mic Distance, g: Mic Spread
This is a simulation of stereo microphone settings.
Rotary Speaker (Top View)
Rotary Speaker - Mic Placement
Early reﬂection and delay effects
041: Early Reﬂections
This effect is only the early reﬂection part of a reverberation
sound, and adds presence to the sound. You can select one of
the four decay curves.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Selects the decay curve for the early reﬂection
ER Time [msec]
Sets the time length of early reﬂection
Pre Delay [msec]
Sets the time taken from the original sound to the ﬁrst early reﬂection
Sets the input level of EQ applied to the effect sound
Pre LEQ Gain [dB]
Sets the gain of Low EQ
Pre HEQ Gain [dB]
Sets the gain of High EQ
Sets the balance between the effect and dry sounds
Selects the modulation source of the effect balance
Sets the modulation amount of the effect balance
This parameter selects the decay curve for the early reﬂection.
Wet / Dry
Wet / Dry
Sharp, Loose, Modulated, Reverse
Dry, 1:99...99:1, Wet
Early Reflections - Type