Specify the scale that the combination will use.
[Equal Temperament...User Octave Scale15]
Select the type of scale ( "Type" Program P1: 1–1c).
Key (Scale Key)
Select the tonic key of the selected scale ( "Key" Program
As this value is increased, an increasingly random devia-
tion will be added to the pitch at each note-on ( "Random"
Program P1: 1–1c)
Combination P3: Edit-MIDI Filter
These settings allow you to apply ﬁlters to the MIDI data
that will be transmitted and received by each timbre 1–8. For
example even if two timbres are being played by the same
MIDI channel, you can make settings so that the damper
pedal will apply to one but not the other.
Checked: Transmission and reception of MIDI data is
enabled. When "Status" (0–1a, 2–1a) is INT, operations of
the built-in controllers or incoming MIDI data will apply the
effect of the checked item to the program of the correspond-
ing timbre. (The effect dynamic modulation function is not
affected by this setting.) When "Status" is EXT or EX2, oper-
ations of the built-in controllers will transmit MIDI data on
the channel of that timbre. MIDI transmission and reception
settings for the entire TRITON are made in "MIDI Filter"
(Global P1: 1–1b).
The MIDI 3 and MIDI 4 tabs contain MIDI ﬁlters for assign-
able controllers (whose function can be set by the user), and
if these are assigned to MIDI control changes, the ﬁlter set-
tings will affect those control changes.
In this case, if the assignable controllers have been set to
control changes that are also found in the MIDI 1 or MIDI 2
tabs, the settings in the MIDI 1 and MIDI 2 tabs will take pri-
ority. Also, if the same control change is assigned to two or
more controllers in the MIDI 3 and MIDI 4 tabs, checking
any one of them will enable that control change.
Unchecked: Transmission and reception of MIDI data is dis-
3–1: MIDI 1
3–1a: Enable Program Change, Enable After Touch,
Enable Damper, Enable Portamento SW
Enable Program Change
Specify whether or not MIDI program change messages will
be transmitted and received.
Enable After Touch
Specify whether or not MIDI after touch messages will be
transmitted and received.
Specify whether or not MIDI control change #64 hold
(damper pedal) messages will be transmitted and received.
Enable Portamento SW
Specify whether or not MIDI control change #65 portamento
on/off messages will be transmitted and received.
(MIDI Filter –1)