Download Print this page

Advertisement

Envelope Select
Selects from linking both channels, controlling only from left channel,
a
only from the right channel, or controlling each channel individually
Ratio
b
Sets the signal compression ratio
Threshold [dB]
c
Sets the level above which the compressor is applied
Attack
Sets the attack time
d
Release
Sets the release time
Gain Adjust [dB]
Sets the output gain
Src
e
Selects the modulation source for the output gain
Amt
Sets the modulation amount of the output gain
Side PEQ Insert
Toggles between on/off of the trigger signal's EQ
f
Trigger Monitor
Switches between effect output monitor and trigger signal monitor
Side PEQ Cutoff [Hz]
Sets the EQ center frequency for the trigger signal
Q
g
Sets the EQ bandwidth for the trigger signal
Gain [dB]
Sets the EQ gain for the trigger signal
Wet/Dry
Sets the balance between the effect and dry sounds
Src
h
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
a: Envelope Select
When L/R Mix is selected for this parameter, the left and right
channels are linked to control the Limiter using the mixed signal.
If L Only (or R Only) is selected, the left and right channels are
linked, and the Limiter is controlled via only the left (or right)
channel.
With L/R individually, the left and right channels control the Lim-
iter individually.
b: Ratio, c: Threshold [dB], e: Gain Adjust [dB]
This parameter sets the signal compression "Ratio". Compression
is applied only when the signal level exceeds the "Threshold"
value.
Adjust the output level using the "Gain Adjust" parameter, since
compression causes the entire level to be reduced.
Output Level
Threshold
Dry
Level
Ratio=Inf : 1
d: Attack, d: Release
These parameters set the attack time and release time. A higher
attack time will cause the compression to be applied more slowly.
156
L/R Mix, L Only, R Only, L/R Individually
1.0:1...50.0:1, Inf:1
–40...0dB
1...100
1...100
–Inf, –38...+24dB
,
Off...Tempo
–63...+63
Off, On
Off, On
20...12.00kHz
0.5...10.0
–18.0...+18.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Limiter - Threshold / Ratio
Ratio=1.0 : 1
Ratio=2.0 : 1
Ratio=4.0 : 1
Ration=Inf : 1
Louder
Input Level
Ratio=1.0 : 1
Ratio=2.0 : 1
Ratio=4.0 : 1
Threshold
Time
Dry
Wet
Wet
f: Side PEQ Insert, g: Side PEQ Cutoff [Hz], g: Q, g: Gain [dB]
These parameters are used to set the EQ applied to the trigger sig-
nal.
The Limiter determines whether the compression is applied or
not, based on the post-EQ trigger signal. Setting the equalizer
allows you to set the Limiter to respond to any frequency band.
f: Trigger Monitor
Setting this parameter On will cause the trigger signal to be out-
put, instead of the effect sound. Use this parameter to check the
trigger signal with EQ applied.
Usually, set this to Off.

004: Multiband Limiter

This effect applies the Limiter to the low range, mid range,
and high range of the input signal. You can control dynamics
for each range to adjust the sound pressure of the low range,
mid range, and high range in a different way from the EQ.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Band-Pass Filters
+
Right
Ratio
a
Sets the signal compression ratio
Threshold [dB]
b
Sets the level above which the compressor is applied
Attack
c
Sets the attack time
Release
d
Sets the release time
Low Offset [dB]
e
Gain of the low-range trigger signal
Mid Offset [dB]
f
Gain of the mid-range trigger signal
High Offset [dB]
g
Gain of the high-range trigger signal
Gain Adjust [dB]
Sets the output gain
Src
h
Selects the modulation source for the output gain
Amt
Sets the modulation amount of the output gain
Limiter - Attack / Release
Threshold
Ratio=Inf : 1
Attack=1
Release=1
Ratio=Inf : 1
Attack=100
Release=100
Release
Attack
Low
Limiter
Envelope - Control
Mid
Low Offset
Limiter
Gain Adjust
Envelope - Control
High
Mid Offset
Limiter
Envelope - Control
High Offset
Wet / Dry
Wet / Dry
1.0:1...50.0:1, Inf:1
Fx:003
–40...0dB
Fx:003
1...100
Fx:003
1...100
Fx:003
–40...0dB
–40...0dB
–40...0dB
–Inf, –38...+24dB
Fx:003,
Off...Tempo
–63...+63

Advertisement

   Also See for Korg TRITON proX

   Related Manuals for Korg TRITON proX

This manual also for:

Triton pro

Comments to this Manuals

Symbols: 0
Latest comments: