Korg TRITON proX Manual page 249

2–B2. Installing a DRAM SIMM
A maximum of two memory boards can be installed
simultaneously. If you wish to use two 32 Mbyte
DRAM SIMM modules, you must first remove the fac-
tory-installed 16 Mbyte DRAM SIMM as described
below in "Removing a DRAM SIMM."
Be sure that the AC power cable remains disconnected
until you have completed all steps of removing the
cover, installing the option board/memory, and re-
attaching the cover.
1 Make sure that cover "B" has been removed. ( "1. Prep-
arations for installation," "1–B. Removing cover "B" for
the EXB-PCM or DRAM SIMM.")
2 Have the DRAM SIMM at hand.
3 Verify the location of the slot into which you wish to
install the DRAM SIMM. With the rear panel of the TRI-
TON facing toward you, the front two rows are the
DRAM SIMM slots.
DRAM SIMM
slots
Factory-installed DRAM SIMM
Rear panel
4 In the slot closest to you, there is a factory-installed 16
Mbyte DRAM SIMM. If you are installing only one mod-
ule, install it in the remaining slot. If you are installing
two DRAM SIMM modules, you will need to remove the
factory-installed DRAM SIMM as explained in "Remov-
ing a DRAM SIMM" so that both slots are available.
5 The notched side of the DRAM SIMM is PIN 1. Install the
DRAM SIMM with its PIN 1 side aligned with the PIN 1
mark ( ) of the slot.
The DRAM SIMM slots and the EXB-PCM slots are
shaped identically. Be careful not to install a board in
the wrong slot.
Rear of the DRAM SIMM
Locking
72PIN
hole
Catches
Rear panel
Catches
EXB-PCM
Slot2
EXB-PCM
Slot1
SIMM
Slot2
SIMM
Slot1
Locking
hole
1PIN
Notch
EXB-PCM
Slot2
EXB-PCM
Slot1
SIMM
Slot2
SIMM
Slot1
6 At a slant, press the DRAM SIMM firmly all the way into
the slot, and raise it to the vertical position until the
catches of the slot click into the locking holes of the
DRAM SIMM. When doing so, pressing the catches of the
slot apart to the left and right will help the board go in
smoothly.
Rear side of DRAM SIMM
Press in at a slant
Rear side of DRAM SIMM
Catch
Raise to vertical
Rear side of DRAM SIMM
7 Reversing the procedure by which you removed cover
"B," re-attach the cover.
8 When all steps have been completed, turn on the power
and make sure that the DRAM SIMM has been installed
correctly. ( "Checking after installation")
Removing a DRAM SIMM
Spread the catches of the slot apart to the left and right, and
(after removing the stoppers from the catches) tilt the
DRAM SIMM and pull it out.
When you spread the catches of the slot apart, the
DRAM SIMM may pop out vigorously and fall into an
opening (inside the instrument). Please be careful.
Rear side of DRAM SIMM
Catch
Rear panel
Rear panel
243