Performing Compensation Of Unevenness Of Button - JUKI AMB-289/IP-420 Instruction Manual

27. PERFORMING COMPENSATION OF UNEVENNESS OF BUTTON

2
When Button positioning motion of the
sewing data is set to "With" and the sewing prepa-
rations are in the completed state, the needle bar
automatically comes down to the angle which has
been set and the compensation of unevenness of
button screen is displayed.
In this state, adjust the relation between button
and needle with 4-direction ARROW MARK but-
tons 1 . Then start sewing.
(Caution) This adjustment value is effective
only for once and cleared after the
completion of sewing.
In addition, when ENTER button
pressed, the present height of the needle bar is
1
inputted to the data of
the time of button positioning of the sewing data
and it becomes the effective value at the time of
next sewing as well.
Reference : See "21. (3) Sewing data
Ⅱ–56
2 is
Needle height at
list".