JUKI AMB-289/IP-420 Instruction Manual page 52

5
6
*1 Cycle data can be copied by the same method.
*2 When deletion is performed in case the remaining pattern No. which has been registered
is one, pattern deletion error (Error code 402) is displayed.
*3 When trying to perform copying to the pattern No. which has been already registered,
copy disapproval error (Error code 401) is displayed.
8
7
Ⅱ–48
4) Input the pattern No. of copy destination.
Input the pattern No. of copy destination with
ten keys 5 . It is possible to retrieve the pat-
tern No. which is not used with –・+ buttons
( 6 ・ 7 ).
5) Start copying.
Press ENTER button
starts.
Pattern No. which has been copied in the se-
lected state returns to the pattern copy (copy
source selection) screen after approximately
two seconds.
8 and copying